Re: Add support for restrictive RLS policies

On 27 September 2016 at 15:15, Jeevan Chalke
<jeevan.chalke@enterprisedb.com> wrote:
> Hello Stephen,
>
> On Tue, Sep 27, 2016 at 12:57 AM, Stephen Frost <sfrost@snowman.net> wrote:
>>
>> Jeevan,
>>
>> * Jeevan Chalke (jeevan.chalke@enterprisedb.com) wrote:
>> > I have started reviewing this patch and here are couple of points I have
>> > observed so far:
>> >
>> > 1. Patch applies cleanly
>> > 2. make / make install / initdb all good.
>> > 3. make check (regression) FAILED. (Attached diff file for reference).
>>
>> I've re-based my patch on top of current head and still don't see the
>> failures which you are getting during the regression tests.  Is it
>> possible you were doing the tests without a full rebuild of the source
>> tree..?
>>
>> Can you provide details of your build/test environment and the full
>> regression before and after output?
>
>
> I still get same failures with latest sources and with new patch. Here are
> few details of my setup. Let me know if I missed any.
>
> $ uname -a
> Linux centos7 3.10.0-327.28.3.el7.x86_64 #1 SMP Thu Aug 18 19:05:49 UTC 2016
> x86_64 x86_64 x86_64 GNU/Linux
>
> HEAD at
> commit 51c3e9fade76c12e4aa37bffdf800bbf74fb3fb1
>
> configure switches:
> ./configure --with-openssl --with-tcl --with-perl --with-python
> --with-ossp-uuid --with-ldap --with-pam --with-zlib --with-pgport=5432
> --enable-depend --enable-debug --enable-cassert --prefix=`pwd`/install
> CFLAGS="-g -O0"

I suggest:

git reset --hard
git clean -fdx
ccache -C

then re-apply patch and re-check.

I've had a couple of issues recently caused by ccache doing something
funky :( but haven't been able to track it down yet.


-- 
 Craig Ringer                   http://www.2ndQuadrant.com/
 PostgreSQL Development, 24x7 Support, Training & Services