Re: Allow escape in application_name (was: [postgres_fdw] add local pid to fallback_application_name)

On 2021/09/02 18:27, kuroda.hayato@fujitsu.com wrote:
> I added the following comments:
> 
> ```diff
> -               /* Use "postgres_fdw" as fallback_application_name. */
> +               /*
> +                * Use pgfdw_application_name as application_name.
> +                *
> +                * Note that this check must be behind constructing generic options
> +                * because pgfdw_application_name has higher priority.
> +                */
> ```

Thanks! What about updating the comments furthermore as follows?

---------------------------------
Use pgfdw_application_name as application_name if set.

PQconnectdbParams() processes the parameter arrays from start to end.
If any key word is repeated, the last value is used. Therefore note that
pgfdw_application_name must be added to the arrays after options of
ForeignServer are, so that it can override application_name set in
ForeignServer.
---------------------------------

> Attached is the fixed version. 0002 will be rebased later.

Thanks for updating the patch!

+		}
+		/* Use "postgres_fdw" as fallback_application_name */

It's better to add new empty line between these two lines.

+-- Disconnect once because the value is used only when establishing connections
+DO $$
+	BEGIN
+		PERFORM postgres_fdw_disconnect_all();
+	END
+$$;

Why does DO command need to be used here to execute
postgres_fdw_disconnect_all()? Instead, we can just execute
"SELECT 1 FROM postgres_fdw_disconnect_all();"?

For test coverage, it's better to test at least the following three cases?

(1) appname is set in neither GUC nor foreign server
        -> "postgres_fdw" set in fallback_application_name is used
(2) appname is set in foreign server, but not in GUC
        -> appname in foreign server is used
(3) appname is set both in GUC and foreign server
       -> appname in GUC is used

+SELECT FROM ft1 LIMIT 1;

"1" should be added just after SELECT in the above statement?
Because postgres_fdw regression test basically uses "SELECT 1 FROM ..."
in other places.

+	DefineCustomStringVariable("postgres_fdw.application_name",
+							   "Sets the application name. This is used when connects to the remote server.",

What about simplifying this description as follows?

---------------
Sets the application name to be used on the remote server.
---------------

+  <title> Configuration Parameters </title>
+  <variablelist>

The empty characters just after <title> and before </title> should be removed?


Regards,

-- 
Fujii Masao
Advanced Computing Technology Center
Research and Development Headquarters
NTT DATA CORPORATION